In the field of audio amplifiers there has been great interest in techniques for making small electrical voltages larger ever since mankind first attempted to transmit the human voice along lengthy telephone cables. This quest received an enormous boost with the introduction of radio broadcasts and the resulting mass production of domestic radio receivers intended to operate a loudspeaker output. However, the final result, in the ear of the listener, although continually improved over the passage of the years, is still a relatively imperfect imitation of the real-life sounds that the engineer has attempted to copy. Although most of the shortcomings in this attempt at sonic imitation are not because of the electronic circuitry and the amplifiers that have been used, there are still some differences between them, and there is still some room for improvement.
I believe, very strongly, that the only way by which improvements in these things can be obtained is by making, analyzing, and recording, for future use, the results of instrumental tests of as many relevant aspects of the amplifier electrical performance as can be devised. Obviously, one must not forget that the final result will be judged in the ear of the listener so that when all the purely instrumental tests have been completed and the results judged to be satisfactory, the equipment should also be assessed for sound quality and the opinions in this context of as many interested parties as possible should be canvassed.
Listening trials are difficult to set up and hard to purge of any inadvertent bias in the way equipment is chosen or the tests are carried out. Human beings are also notoriously prone to believe that their preconceived views will prove to be correct. The tests must therefore be carried out on a double-blind basis, when neither the listening panel nor the persons selecting one or other of the items under test knows what piece of hardware is being tested.
If there is judged to be any significant difference in the perceived sound quality, as between different pieces of hardware that are apparently identical in their measured performance, the type and the scope of the electrical tests that have been made must be considered carefully to see if any likely performance factor has been left unmeasured or not given adequate weight in the balance of residual imperfections that exist in all real-life designs.
A further complicating factor arises because some people have been shown to be surprisingly sensitive to apparently insignificant differences in performance or to the presence of apparently trifling electrical defects—not always the same ones—so, because there are bound to be some residual defects in the performance of any piece of hardware, each listener is likely to have his or her own opinion of which of these sounds best or which gives the most accurate reproduction of the original sound—if this comparison is possible.
The most that the engineer can do, in this respect, is to try to discover where these performance differences arise or to help decide the best ways of getting the most generally acceptable performance.
It is simple to specify the electrical performance that should be sought. This means that for a signal waveform that does not contain any frequency components that fall outside the audio frequency spectrum, which may be defined as 10 Hz to 20 kHz, there should be no measurable differences, except in amplitude, between the waveform present at the input to the amplifier or other circuit layout (which must be identical to the waveform from the signal source before the amplifier or other circuit is connected to it) and that present across the circuit output to the load when the load is connected to it.
In order to achieve this objective, the following requirements must be met.
In addition to these purely electrical specifications, which would probably be difficult to meet, even in a very high-quality solid-state design—and most unlikely to be satisfied in any transformer-coupled system—there are a number of purely practical considerations, such as that the equipment should be efficient in its use of electrical power; that its heat dissipation should not present problems in housing the equipment; and that the design should be cost-effective, compact, and reliable.