Deploying a Single Edge Server Pool

If you are deploying a single Edge Server Pool, follow these steps:

1. Select Single Computer Pool, and click Next.

2. If a single public IP address will be used for the Access Edge, Web Conferencing Edge, and A/V Edge services, check the box Use a Single FQDN and IP Address. This requires using ports other than 443 for two of the services.

3. If federation will be used, check the Enable Federation box.

4. If XMPP federation will be used, check the Enable XMPP Federation box, and then click Next.

5. Check valid IP options as they relate to your deployment. If your deployment is using IPv6, check the IPv6 boxes for the internal and external interface. If not, ensure that only the IPv4 boxes are checked.

6. If the IP address used for the A/V Edge uses NAT, check the box The External IP Address of This Edge Pool Is Translated by NAT. Click Next when complete.

7. Under the Access Edge Service section, enter the external FQDN and port. Typically, this is similar to sip.companyabc.com and port 443.

Note

If you elected to use a single FQDN and IP address for your public edge services, you will be permitted to enter only a single FQDN, and the default ports will be set to 5061, 444, and 443.

8. Under the Web Conferencing Edge Service section, enter the external server FQDN and port. Typically, the name and port are similar to webconf.companyabc.com and port 443.

9. Under the A/V Edge Service section, enter the external server FQDN and port. Typically, the name and port are similar to av.companyabc.com and port 443. Click Next when complete.

Note

If you are using IPv6 in your environment, and have selected to enable IPv6 on the Edge Server, you will be required to enter the IPv6 and/or IPv4 address for each Edge Server.

10. Enter the internal-facing IP address for the Edge Server Pool and click Next.

11. Under the Access Edge Service section, enter the external IP address.

12. Under the Web Conferencing Edge Service section, enter the external IP address.

13. Under the A/V Edge Service section, enter the external IP address. When finished, click Next.

14. Select a next-hop pool to be used by the Edge Server pool and click Next. If a director is deployed, you should select the director as the next-hop.

15. Select any Front End Server pools or Mediation Server pools that will use this Edge Server pool for external media traffic. Click Finish to complete the wizard.

..................Content has been hidden....................

You can't read the all page of ebook, please click here login for view all page.
Reset